Transport belt to deal with the scattering material.

 

The scattering material transport belt is a common problem, the reasons are multi-faceted. But the focus is to strengthen the day-to-day maintenance and repair.

       1. Reprinted point spread point spread material reproduced materials primarily in the drop-hopper, trough, etc. Introduction. Such as a serious overload transport belt, the guide trough belt conveyor rubber block rocker covers material damage, guided the design of steel trough Agency belt away from the rubber rocker covers off a long lead materials trough. In the control of the situation on the delivery of capacity, to strengthen the maintenance to be resolved.
 
       2. Au vacant belt at the time of Caesar feed belt interval when Au Au small radius of curvature will have a vacant belt, a belt into a trough at this time the situation changes, as has already left the trough belt idler group, the general slot angle become smaller, so that some material from spreading. Therefore, at the design stage should be as much as possible Au larger radius of curvature to avoid the occurrence of such cases. Such as mechanical loading in the mobile machine, stacker-reclaimer equipment and vehicles in order to shorten the tail will be designed here Au range of non-arc transition, when the belt smaller than the width of selection is easier to spread on the material.
 
       3. Deviation is expected at the time of Caesar Caesar belt at the time of expected deviation due to the two belts at the edge of a high degree of run-time changes in the high side, while the other side of the low side of materials from low-spreading out of the way to deal with adjustment belt deviation

The news come from www.bossgoo.com